Welcome, Guest

TOPIC: compiling program offline

compiling program offline 4 years 8 months ago #1306

  • kenobe2014
  • kenobe2014's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 19
  • Karma: 0
Hi
I created a new project with my own program in the smi 2.4 smart motor interface.
I did not connect to the hardware.
My problem is that I can not compile, the error is : A,V,P are undefined symbol.
Must i connect to the hardware before i can compile the program?
Thanks for advise
The administrator has disabled public write access.

Re: compiling program offline 4 years 8 months ago #1307

  • csearcy
  • csearcy's Avatar
  • OFFLINE
  • Moderator
  • Posts: 459
  • Thank you received: 77
  • Karma: 23
Go to the Compile menu. Select Compiler default firmware version. Select the firmware version that applies to your motor. You can find the firmware version on the motor sticker. It is also shown in the Configuration window of SMI2 if you connect and detect the motors.
The administrator has disabled public write access.
The following user(s) said Thank You: kenobe2014, winie06

Re: compiling program offline 4 years 3 months ago #1501

  • winie06
  • winie06's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Thank you! your answer was very helpful. I've seen a lot of different answers and non of them worked.
The administrator has disabled public write access.
Moderators: hsummer, csearcy, swalters, mmeyers
Time to create page: 0.242 seconds
Powered by Kunena Forum