Welcome, Guest
Messages posted to this category need to be reviewed by the moderator before it gets posted.

TOPIC: How to control smartmotor from a C programmed software

How to control smartmotor from a C programmed software 2 years 4 months ago #2255

  • motorguru
  • motorguru's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Dear all,

i am newbee in working with smartmotor. And in my application i would like to write a program interface in C language to control a smartmotor for example:
+ I can give the end speed or end position, start, stop... for the motor from the C programmed software

Can anyone show me how to do it (software and hardware connection)? or where can i find document about this?

Thanks.
The administrator has disabled public write access.

How to control smartmotor from a C programmed software 4 weeks 2 days ago #2305

  • swalters
  • swalters's Avatar
  • OFFLINE
  • Moderator
  • Posts: 5
  • Karma: 0
Which ASCII characters you send is outlined in our SmartMotor Developer's Guide (for Class 5 or later) or Language Reference Guide (for legacy Class 4). For example, if you want to set a velocity target, you would send the characters "VT=x " where x is the target. The hex values for these characters are 56, 54, 3D, 78, 20. For a full description of how to execute motion, please read through the documents referenced above.
Did you restart it?
The administrator has disabled public write access.
Moderators: hsummer, csearcy, swalters, mmeyers
Time to create page: 0.523 seconds
Powered by Kunena Forum