Welcome, Guest
Username Password: Remember me
Messages posted to this category need to be reviewed by the moderator before it gets posted.
  • Page:
  • 1

TOPIC: Communication with stepper driver

Communication with stepper driver 2 months, 1 week ago #2288

  • ABauvin
  • OFFLINE
  • Posts: 2
  • Karma: 0
Hi,
I am now trying to have my master motor (SM34165DT) to send basic orders (change variable values) in a programmable stepper motor driver (LAM Technologies) using RS485.
I set up same parameters in both devices. Stepper driver is running with Modbus RTU Protocol.
If compatible, how should I send messages (in data mode or command, which synthax...)?
Exemple: Driver Adress: 10
Adress of word to modify: 0xA002
Thanks
  • Page:
  • 1
Moderators: hsummer, csearcy
Time to create page: 0.43 seconds