Welcome, Guest
Username Password: Remember me
  • Page:
  • 1

TOPIC: smnc

smnc 2 years, 6 months ago #1475

  • Cesar
  • Posts: 9
  • Karma: 0
hi, we have a small milling maching with no servomotors, so we will use 3 SM23165DT with planeteary gearheads (10:1) for x,y,and z axis

the problem is we have to do half-turn the screw ball before the load move (I suppous that is what they call BACKLASH)

can smnc software compensate that?

Re: smnc 2 years, 6 months ago #1477

  • csearcy
  • Posts: 480
  • Karma: 23
There is not any "built-in" backlash compensation in the SMNC software. If you have backlash in the system, you must compensate for it with your G-Code.
  • Page:
  • 1
Moderators: hsummer, csearcy
Time to create page: 0.39 seconds