Welcome, Guest
Username Password: Remember me
  • Page:
  • 1

TOPIC: ADB checksum error

ADB checksum error 4 years, 11 months ago #287

  • Cesar
  • OFFLINE
  • Posts: 9
  • Karma: 0
Hi everyone, I am having some problems with my Smartmotor (sm2316dt), actually I am not able to make a single move, I must say that The Status Word Bo is on (so Motor is off), I have sent Zs command but It can not clear it, also The STATUS WORD 2 BIT 9 (adb bad checksum error) is always on
Can someone help me?

also every time I try to find this motor I get this message:

ADB (animatics data block bad)Read

One or more errors were found while reading the data block form Motor Motor1-com2.

the checksum calculated from the data block did not match the one stored in the data block.

A program executin a PRINT command could interfere with reading the data block.Issue an End command to all motors on this port and try again.

I already sent a END command but I can not clear Bo

thanks in advance and sorry for my bad english
Last Edit: 4 years, 11 months ago by Cesar.

Re: ADB checksum error 4 years, 11 months ago #288

  • Cesar
  • OFFLINE
  • Posts: 9
  • Karma: 0
Sorry Smartmotor is SM23165dt
  • Page:
  • 1
Moderators: hsummer, csearcy
Time to create page: 0.37 seconds