Welcome, Guest
Username Password: Remember me
  • Page:
  • 1

TOPIC: harware

harware 3 years, 10 months ago #749

  • palani1
  • OFFLINE
  • Posts: 1
  • Karma: 0
sir


i am not able to move the motor .i am getting excessive position error.how to solve this

Re: harware 3 years, 10 months ago #752

  • csearcy
  • OFFLINE
  • Posts: 480
  • Karma: 23
What is the model number and firmware revision on the motor?
This info should be on one or more stickers on the motor.

In most cases... you can use the SmartMotor Playground to run the motor in Torque Mode. This mode does not require use of the encoder. Be sure to check the boxes in the lower right corner of the Playground window to disable travel limits (if you have nothing connected to those inputs).
  • Page:
  • 1
Moderators: hsummer, csearcy
Time to create page: 0.42 seconds