Peripherals/ arrow Expanded I/O/ arrow AniLink Analog I/O Card

AniLink Analog I/O Card



The AIO-100 is a four input, one-output analog I/O peripheral module to be used with SmartMotors and related control products. The card connects through the Anilink™ bus. This module allows an Moog Animatics controller to read analog signals from external devices or control an external system with an analog signal. The range of signal voltage for both input and output is adjustable to a maximum of 0 to +5 VDC with eight bits of resolution. Upper and lower limits are independently adjustable for the A/D or D/A functions, allowing the full 8 bit accuracy to be applied to small signal ranges. Each input channel can be centered independently. Up to eight AIO-100 modules can be addressed by a single SmartMotor™. The card is powered by +5 V and ground from the SmartMotor™ or controller. These units are equipped with a voltage regulator allowing support from an external +6V to +24 V source.

The AIO-110 has four analog inputs, one 0 to 10 VDC and three 0 to 5 V. There is one analog output that creates 0 to +10 VDC and scaled output of 0 to +5 VDC. The resolution of the output signal is 8 bit.

aio100 AIO-110
AIO-100 AIO-110

One analog output.
Four analog inputs.
Two parallel auxiliary inputs.
AniLink compatible.
Firmware supported.

Allows AniLink™-equipped controller to control outside processes.
Efficient control feedback or data input, independently tunable.
Panel/controller parallel inputs; operator convenience and safety.
Simple plug-in operation.
Easily programmable: Series 5000 or SmartMotor™ controls.
Special firmware support for porportional joystick applications
on Series 5000 controllers.

Bus DC line voltage: 5VDC
Auxiliary Power Input: + 6 to +24VDC
Normal Maximum DC Current: 40 mA
Inputs (four): 0 - 5VDC max., 8 bits accuracy
Output (one): 0 - 5VDC max., 8 bits accuracy

Dimensions: see figure
Weight: 1oz (28g)

Operating Temperature: 0 to 50? C
Storage Temperature: -20 to 70? C
Humidity: 0 to 90% non condensing