CBLSMCDS-xM

CBLSMCDS-xM is a simple, single cable capable of carrying power, RS-232 and CAN bus communications from motor to motor using only the 7W2 connector. For Moog Animatics SmartMotor™ servos equipped with the CDS7 option.


+
-


Specification

CBLSMCDS series is the "Add-A-Motor"-style power and communications cable for CDS7-equipped SmartMotors. It consists of a feed-thru 7W2 main motor connector split out to a single second motor 7W2 connector. This single cable is capable of carrying power, RS-232 and CAN bus communications from motor to motor using only the 7W2 connector. With the CDS7 option and CBLSMCDS cable(s), you no longer have to use the motor's DB-15 connector for CAN bus communications from motor to motor -- it is already built into the CBLSMCDS cable!

NOTE: CBLSMCDS series cables with blue overmolded connectors are designed for the Class 5 D-Style SmartMotor with the CDS7 option only! DO NOT use these cables with standard Class 5 D-Style SmartMotors.

The CBLSMCDS cable is designed to allow ease of connection to multiple motors in a single daisy-chain network carrying power, RS-232 and CAN bus communications. The main power ground wire is a larger gauge to decrease noise emissions at the ground-plane level. All communications lines are internally shielded from the power lines.

NOTE: The two end nodes of the CAN bus network must be terminated with a 120 ohm terminator (shunt) for proper biasing. If an end node is a SmartMotor, a pass-thru terminator is availble (PN: CBLSM-TR120) that attaches directly to the motor's 15-pin D-sub connector to serve as the terminator.

Part NumberLength
unit in meter
CBLSMCDS-0.3 0.3
CBLSMCDS-1.0 1
CBLSMCDS-3.0 3
CBLSMCDS-7.5 7.5


Drawing

Due to gauge of the main power lines, it is not recommneded to use the CBLSMCDS "Add-A-Motor" cables with the larger 34 frame SmartMotor™. If there is just one 34 frame SmartMotor™ in a system design, then it should be the first motor in the chain to minimize voltage drop effects over the entire network.

Figure 1

CBLSMCDS-xm-drawing

Figure 2

CBLSMCDS-xm-drawing

Connector Pinouts

CDS7_cable_pinout

Cable Spec & Drawing Downloads:



+
-