Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Motor will "RUN?"...but it will not "RUN"

Motor will "RUN?"...but it will not "RUN" 2 years 6 hours ago #2256

SM2316MT-IP-DN firmware 5.97
The motor will not RUN it's program the "Z" command is issued
It WILL run when the "RUN?" is the first line and the RUN command is issued from the serial line

Have exhausted all sample code... Cannot get the motor to run at startup.
The administrator has disabled public write access.

Re: Motor will "RUN?"...but it will not "RUN" 2 years 5 hours ago #2258

  • csearcy
  • csearcy's Avatar
  • OFFLINE
  • Posts: 459
  • Thank you received: 77
  • Karma: 23
You need to have Drive Enable tied to 24VDC on the I/O port. If you can't run it with the SMI Playground (considering you have to either used limit switches or disable them with the EIGN(2) EIGN(3) commands) you need to check for faults or a Drive Off condition.
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: hsummer, csearcy
Time to create page: 0.273 seconds