Moog Animatics Support Forum :: Topic: EEPROM (1/1)

Welcome, Guest

TOPIC: EEPROM

EEPROM 8 years 11 months ago #56

Sherwood OFFLINE Fresh Boarder Posts: 5 Karma: 0	Two questions regarding non-volatile storage: 1) Does either the SM2315D or SM2315DT contain a data EEPROM? 2) Presumably, both contain a program EEPROM; what is its size?
	The administrator has disabled public write access.

Re: EEPROM 8 years 11 months ago #57

mtran OFFLINE Fresh Boarder Posts: 2 Karma: 0	1) The SM2315D and SM2315DT now include EEPROM for Long Term Data memory to be used with EPTR=, VST, and VLD commands. 2. Both the Long Term Data Memory and Programming memory are 32KByte in size.
	The administrator has disabled public write access.

Re: EEPROM 8 years 11 months ago #58

Sherwood OFFLINE Fresh Boarder Posts: 5 Karma: 0	Is this also true for SM2315D and -DT that were shipped in the past? I am running a test using EPTR=, VST and VLD that doesn't perform as expected.
	The administrator has disabled public write access.

Re: EEPROM 8 years 11 months ago #59

mtran OFFLINE Fresh Boarder Posts: 2 Karma: 0	In the past, this would be an option. The part number will be SM2315M for the SM2315D and SM2315MT for SM2315DT. The M is for Long Term Data Memory. If the EPTR=, VST, and VLD commands used and the value was not stored, then the motor does not have this memory.
	Last Edit: 8 years 11 months ago by mtran. The administrator has disabled public write access.

Re: EEPROM 7 years 3 months ago #651

bmick08 OFFLINE Fresh Boarder Posts: 19 Karma: 0	Is the only restriction to setting EPTR the 32,339 mark? I have only one variable to store at the moment, so should I just set EPTR = 0? (Motor Model 21365D)
	The administrator has disabled public write access.

Re: EEPROM 7 years 3 months ago #654

csearcy OFFLINE Moderator Posts: 463 Thank you received: 79 Karma: 23	Yes. EPTR=0 is acceptable.
	The administrator has disabled public write access. The following user(s) said Thank You: bmick08

Moderators: hsummer, csearcy, swalters, animatics, mmeyer

Time to create page: 0.147 seconds

Powered by Kunena Forum