Welcome, Guest

TOPIC: Go to origin after home

Go to origin after home 5 years 5 days ago #1169

  • Randy2959
  • Randy2959's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
I use a hard stop to home. And after home the 3 axis are to go to origin. Twice now the origin has not repeated. I was .33 off on x. .800 off on y and .5 off on z...

Anyone have the same problem
The administrator has disabled public write access.

Re: Go to origin after home 5 years 3 days ago #1170

  • csearcy
  • csearcy's Avatar
  • OFFLINE
  • Moderator
  • Posts: 459
  • Thank you received: 77
  • Karma: 23
Make sure you don't have any mechanical slippage in the couplings.
The administrator has disabled public write access.
Time to create page: 0.243 seconds
Powered by Kunena Forum