Welcome, Guest

TOPIC: smnc

smnc 4 years 6 months ago #1475

  • Cesar
  • Cesar's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 7
  • Karma: 0
hi, we have a small milling maching with no servomotors, so we will use 3 SM23165DT with planeteary gearheads (10:1) for x,y,and z axis

the problem is we have to do half-turn the screw ball before the load move (I suppous that is what they call BACKLASH)

can smnc software compensate that?
The administrator has disabled public write access.

Re: smnc 4 years 6 months ago #1477

  • csearcy
  • csearcy's Avatar
  • OFFLINE
  • Moderator
  • Posts: 459
  • Thank you received: 77
  • Karma: 23
There is not any "built-in" backlash compensation in the SMNC software. If you have backlash in the system, you must compensate for it with your G-Code.
The administrator has disabled public write access.
Time to create page: 0.235 seconds
Powered by Kunena Forum