Hi everyone, I am having some problems with my Smartmotor (sm2316dt), actually I am not able to make a single move, I must say that The Status Word Bo is on (so Motor is off), I have sent Zs command but It can not clear it, also The STATUS WORD 2 BIT 9 (adb bad checksum error) is always on
Can someone help me?
also every time I try to find this motor I get this message:
ADB (animatics data block bad)Read
One or more errors were found while reading the data block form Motor Motor1-com2.
the checksum calculated from the data block did not match the one stored in the data block.
A program executin a PRINT command could interfere with reading the data block.Issue an End command to all motors on this port and try again.
I already sent a END command but I can not clear Bo