Welcome, Guest

TOPIC: Standard SmartMotor Controller and Drive Specifications:

Standard SmartMotor Controller and Drive Specifications: 10 years 8 months ago #49

  • Animaticsv15
  • Animaticsv15's Avatar
  • Administrator
  • Posts: 44
  • Thank you received: 3
  • Karma: 0
All Standard SmartMotors should be powered from 18VDC to 48VDC. Under no circumstances should they be allowed to run off of any higher voltages. Lower voltages could cause a brownout shutdown of the CPU or what would appear as a down power reset under sudden load changes. If power is reversed on any standard SmartMotors, immediate damage WILL occur and the SmartMotor will no longer operate.

Note: During hard fast decelerations, a SmartMotor can pull up supply voltages to the point of damage if a shunt resistor pack is not use
The administrator has disabled public write access.
Time to create page: 0.140 seconds
Powered by Kunena Forum