Welcome, Guest
Messages posted to this category need to be reviewed by the moderator before it gets posted.

TOPIC: Controlling motor steps using I/O

Controlling motor steps using I/O 3 years 1 month ago #2129

I would like to control the smart motor using a On/Off signal from I/O pin 2. I am cycling a tool into a port and when it signals a high I want to use code to release the tool back to a low within a 4 second time frame. Can someone help me with programming?
The administrator has disabled public write access.

Re: Controlling motor steps using I/O 3 years 1 month ago #2131

  • csearcy
  • csearcy's Avatar
  • OFFLINE
  • Moderator
  • Posts: 459
  • Thank you received: 77
  • Karma: 23
What is the part number or firmware revision of your SmartMotor?

Are you wanting a 4 second delay before it moves out? ...or do you want the move to take 4 seconds?
The administrator has disabled public write access.

Re: Controlling motor steps using I/O 3 years 1 month ago #2134

SM23375DT

I want to tell the motor to move in or out based on signal from input #6. When my script program goes high I want to move motor in until script is finish which then sets to low and move the motor back out. The delay I can work into that.
The administrator has disabled public write access.
Time to create page: 0.223 seconds
Powered by Kunena Forum