Overlay text here
Notifications
Clear all
Topic starter
Hello my dears,
I tried to communicate with SmartMotor(the model is SM3146DDEBRSEV, version is 4.78AE)by RS232 in using SMI software. I used 3-pin and 4-pin in 7W2 Combo D-sub to connect to my PC. I have tried these two methods in （ http://cn.animatics.com/forum/communications/1401-rs232-problem-comunication.html）， but it didn't work. Now I don't know what should I do. Please help me.
Posted : 16/10/2014 5:52 pm
You should have the following...
pin 2 on the 9-pin D-Sub connected to pin 3 on the 7W2.
pin 3 on the 9-pin D-Sub connected to pin 4 on the 7W2.
pin 5 on the 9-pin D-Sub connected to pin 5 on the 7W2.
Posted : 16/10/2014 6:04 pm
Topic starter
Yes, i do that. And i am sure I can get message when i connected 3-pin and 4-pin. The SERVO-AMPLIFIER LED is red. AND another led isn't lighting.
Posted : 16/10/2014 6:17 pm
ok... So if you type RP in the blue terminal window... you get a response from the motor? ...and if it's 0 ...you can turn the shaft and type RP again... and get a different number?
Make sure you have the latest version of SMI2 software from www.animatics.com
You may just need to either put the following commands in a program and download it to the motor... or type them in the blue terminal window...
UCI
UDI
ZS
...and to make the shaft move one revolution... type the following...
MP
A=100
V=100000
D=4000
G
...if you make a program.. it must also include an END command. The TWAIT command can be used in a program to pause program until the current move completes.
Posted : 16/10/2014 6:24 pm
The following link has a page with tabs... manuals and sample programs... etc. ..for your motor.
http://www.animatics.com/legacy-downloads.html?task=view
Note: To properly compile for your motor in the SMI2 software... Click on the Compile Menu... then select "compiler default firmware version". You will get a list. Select 478T. This version will understand the command set for your motor.
Posted : 16/10/2014 6:42 pm
The following link has a page with tabs... manuals and sample programs... etc.
http://www.animatics.com/legacy-downloads.html?task=view
Note: To properly compile for your motor in the SMI2 software... Click on the Compile Menu... then select "compiler default firmware version". You will get a list. Select 478T. This version will understand the command set for your motor.
Posted : 16/10/2014 6:42 pm