Smartmotor Cyclic Displacement in Labview - Communications

Smartmotor Cyclic Displacement in Labview

csearcy — Fri, 24 Jul 2015 16:47:55 +0000

Try adding the TWAIT and a WAIT... just to see if it's really settling into position. You may have to tighten up the tuning a little. 'To elaborate a bit more SADDR1 A=1000 V=100000 MP O=0 a=0 WHILE a<10 D=2000 'YOU MAY WANT TO USE P=2000 G TWAIT WAIT=4069 'Wait one second D=-2000 'YOU MAY WANT TO USE P=0 G TWAIT WAIT=4069 'Wait one second LOOP END

Smartmotor Cyclic Displacement in Labview

kremley — Fri, 24 Jul 2015 16:17:23 +0000

No, but I just tried and it did not seem to make a difference.

Smartmotor Cyclic Displacement in Labview

kremley — Fri, 24 Jul 2015 16:12:39 +0000

No, but I just tried using it and it did not seem to make a difference.

Smartmotor Cyclic Displacement in Labview

kremley — Fri, 24 Jul 2015 16:10:56 +0000

No, but I tried using it and it did not seem to make a difference.

Smartmotor Cyclic Displacement in Labview

kremley — Fri, 24 Jul 2015 16:06:09 +0000

No, but I just tried using it and it did not seem to make a difference.

Smartmotor Cyclic Displacement in Labview

csearcy — Fri, 24 Jul 2015 15:58:58 +0000

Are you using the TWAIT command after the G?

Smartmotor Cyclic Displacement in Labview

kremley — Fri, 24 Jul 2015 15:55:28 +0000

Hi, I'm trying to create a cyclic displacement program in Labview using my SM1720M version 4.15b. I currently have a program that mostly works. I send the command using D,A,V and G. The only difference in between the up and down command, is I negate the displacement command. The problem is the motor moves 2-3 counts shorter down than up even though it's sending the exact same command both ways. Any help would be greatly appreciated! I'm not using the TWAIT command. I tried using it and it did not seem to make a difference.