Notifications
Clear all
Topic starter
Hi
I created a new project with my own program in the smi 2.4 smart motor interface.
I did not connect to the hardware.
My problem is that I can not compile, the error is : A,V,P are undefined symbol.
Must i connect to the hardware before i can compile the program?
Thanks for advise
Posted : 04/01/2014 5:32 pm
Go to the Compile menu. Select Compiler default firmware version. Select the firmware version that applies to your motor. You can find the firmware version on the motor sticker. It is also shown in the Configuration window of SMI2 if you connect and detect the motors.
Posted : 05/01/2014 1:31 pm
Thank you! your answer was very helpful. I've seen a lot of different answers and non of them worked.
Posted : 18/06/2014 7:55 am